Stamping factories can produce different kinds of metal stamping parts, and round stamping parts are also one of them. So, when producing circular stamping parts, what processing steps should we take and what should we pay attention to?

1. Strip-shaped materials that need to be formed into circular stamping parts;

2. Put the main body of the circular stamping strip material used for forming into a two-cavity blanking die for stamping processing. In the stamping process, first locate the bar on the two inclined edges of the parallelogram length, and then position the bar through the hole edge of the circular stamping part after the blanking;

3. In order to improve the processing efficiency, two rows of circular stamping parts can be set in the material belt, and the two rows of circular stamping parts can be staggered; when the stamping parts are processed, the positioning of the material belt is located on the four sides of the rectangular material belt Although this method improves the processing efficiency, the utilization rate of stamping materials is not high, and the processing cost is relatively increased.

4. The horizontal cross section of the formed circular punch is a parallelogram, and both sides of the parallelogram are inclined in the length direction. The circular stamping parts made from the strip can improve the material utilization rate and reduce the processing cost. Simultaneous stamping. During the processing, the material belt needs to be positioned once during each stamping process, so that the quality of the round stamping parts produced will be better.